Steam Cracking Process

A typical ethane cracker has several identical pyrolysis furnaces in which fresh ethane feed and recycled ethane are cracked with steam as a diluent. Figure 1.1 is a block diagram for ethylene from ethane. The outlet temperature is usually in the 800°C range. The furnace effluent is quenched in a heat exchanger and further cooled by direct contact in a water quench tower where steam is condensed and recycled to the pyrolysis furnace. After the cracked gas is treated to remove acid gases, hydrogen and methane are separated from the pyrolysis products in the demethanizer. The effluent is then treated to remove acetylene, and ethylene is separated from ethane and heavier in the ethylene fractionator.  The bottom fraction is separated in the deethanizer into ethane and C3fraction. Ethane is then recycled to the pyrolysis furnace.

Figure 1.1. Block diagram for producing ethylene from ethane.

An olefin plant that uses liquid feeds requires an additional pyrolysis furnace, an effluent quench exchanger, and a primary fractionator for fuel oil separation.

مواضيع ذات صلة

سلوك المعادن الطينية في علاقتها مع الماء

تصنيف النفط الخام Classification of Crude Oils

التحليل المطلق Ultimate Analysis

المكونات الرئيسية للنفط الخام الموجود في منطقة القيارة

نفط خام القيار

النفط الخام ومكوناته

النفط والطاقة Oil and Energy

مزائج اسفلت – اسفلتين

أساليب تحوير المواصفات الريولوجية للاسفلت

صفات الاسفلت الريولوجية Properties of Asphalt Rheological

استخدامات الاسفلت Asphalt Uses of

التركيب الكيميائي للاسفلت Chemical Composition of Asphalt