Cationic Polymerization

Various Lewis and protonic acids are capable of initiating cationic polymerization of epoxies. Among them, the following metal salts are effective in polymerizations of ethylene and propylene oxides [3, 4]: ZnCl₂, AlCl₃, SbCl₅, BF₃, BCl₃, BeCl₂, FeCl₃, SnCl₄, and TiCl₄. Often these polymerizations can be carried out in bulk without any solvent, particularly in the laboratory. The mechanism of these reactions can be complex, however, depending upon the particular Lewis acid used. In fact, not all of these polymerizations can even be treated in general terms as cationic. For instance, ferric chloride-initiated polymerizations of epoxides initially proceed by a mechanism that has all the superficial features of cationic polymerization. After the initial stages, however, the polymerizations proceed by a coordination mechanism. This is discussed further in this section. Stannic chloride yields only low molecular weight poly (ethylene oxide) from ethylene oxide (molecular weight below 5,000) when the reaction is carried out in ethylene chloride at room temperature. Some dioxane and dioxolane also form in the process. Following reaction scheme was proposed [2–6]:

Initiation

Propagation

The initiation step depends upon formation of oxonium ions. Because a carbon cation intermediate is indicated, it was suggested [4] that the propagation probably occurs by ether exchange that results from a nucleophilic attack by the monomer on the oxonium ion. Boron trifluoride forms complexes with oxygen-containing compounds, like water, alcohols, and ethers. When it initiates the polymerization of epoxides, it can associate simultaneously with several different moieties. These are the monomeric cyclic ethers, as well as the open-chain polymeric ether groups, and the hydroxy groups on the chain ends. In addition it can also associate with the hydroxy groups of water. The following illustration shows the type of equilibrium that can take place [2]:

The alcohols and open-chain ethers have comparable basicities toward the coordinated acid ROH: BF3. Ethylene oxide, on the other hand, is much less basic than the open-chain ethers [6]. In the initiation step, therefore, the monomer reacts with the coordinated acid [1]:

During propagation three different reactions can occur [2]:

This reaction is also accompanied by formation of dioxane. It is actually a step of depolymerization:

The ring-opening reaction, a nucleophilic substitution, usually takes place with an inversion of configuration at the carbon atom that undergoes the nucleophilic attack [8, 9, 11]. This can be illustrated as follows:

Alkyl substituents on the ethylene oxide ring enhance the process of cationic polymerization. For instance, ethylene oxide yields only low molecular weight oils with strong Lewis acids. Tetramethy- lethylene oxide, on the other hand, is converted readily by BF3 into high molecular weight polymers that are insoluble in common solvents [10] When proton donors initiate the polymerizations of epoxides, only low molecular weight products result. The reaction is quite straightforward. Oxonium ions form during the initiation step as follow:

Propagation is the result of a ring-opening attack by a monomer:

Chain-growth can terminate by a reaction with water:

In cationic polymerizations of propylene oxide the ring-opening step involves a direct attack on the oxonium ion at the carbon that bears a more labile bond to the oxygen:

Cationic ring-opening polymerization of oxiranes can also be carried out photochemically (photo- chemical reactions are discussed in Chap. 10). Yagci and coworkers reported polymerizations of cyclohexene oxide with the aid of highly conjugated thiophene derivatives [12]. The reaction is illustrated as follows:

The cationic polymerization was initiated at room temperature upon irradiation with light in the visible region in CH₂Cl₂ solutions in the presence of diphenyliodonium hexafluorophosphate and the thiophene derivative. According to the suggested mechanism, Ayodgan et al. [12] discuss the formation of exciplex (see Chap. 10) by the absorption of light. Subsequent electron transfer from excited Photosensitizer to iodonium ion yields radical cations of the thiophene derivatives. The resulting strong Bronsted acid derived from this process catalyzes the cationic polymerization.

اخر الاخبار

اخبار العتبة العباسية المقدسة

العتبة العباسية المقدسة تختتم فعاليات يوم الخدمة بذكرى ولادة أبي الفضل العباس (عليه السلام)

العتبة العباسية المقدسة تكرم منتسبيها المتميزين خلال عام 2025

العتبة العباسية المقدسة تكرم أقسامها المتميزة في تقديم أفضل تقرير سنوي ضمن فعاليات يوم الخدمة

ضمن فعاليات يوم الخدمة.. العتبة العباسية المقدسة تكرِّم عوائل المنتسبين المتوفين خلال عام 2025

المزيد

الآخبار الصحية

دراسة: محاولة متعمدة لنشر الإنفلونزا تنتهي بـ"مفاجأة"

من خبير في هارفارد.. 6 نصائح يومية "فعالة" لإبطاء الشيخوخة

7 مشروبات طبيعية لتقوية الذاكرة وزيادة التركيز

عرض شائع على الأصابع.. قد يكشف سرطان الرئة مبكرا

المزيد

الآخبار التكنلوجية

وسائل التواصل بين الإفراط والامتناع.. ما هو الحد الآمن للمراهقين؟

أعمق خندق في الكوكب الارض !

روساتوم: روسيا تقترب من تطوير ساعات ذرية فائقة الدقة

مفاجأة علمية عن الإنجاب.. كم طفلا يطيل عمر المرأة؟

المزيد

مواضيع ذات صلة

Steric Control in Polymerizations of Oxiranes

Polymerization by Coordination Mechanism

Kinetics of Ring-Opening Polymerization

Chemistry of Ring-Opening Polymerizations

Configurational Statistics and the Propagation Mechanism in Chain-Growth Polymerization

Group Transfer Polymerization

Copolymerizations by Ionic Mechanism

Polymerization of Ketones and Isocyanates

Polymerizations of Di Aldehydes

Polymerization of Unsaturated Aldehydes

Anionic Polymerization of Aldehydes

Polymerization of Aldehydes